vibration along pipeline

$30-250 SGD

Selesai

Dibuat

sekitar 10 tahun yang lalu

$30-250 SGD

Dibayar ketika dikirim

Hi, I am doing a project on vibration along pipeline. I am planning to build a tank with a pump that regulate flow rate of water in the pipeline. A micro vibration sensor is to be soldered onto a PCB board, which must be able to mount on the pipe (diameter 25mm). Flow meter is required for measuring the water flow rate. (is about 1550L/min) Thereafter, I will connect the readings from the sensor to software such as Labview (preferably to have output value). (you will be required to assist in the programming for the physical readings to be input into software such as Mathlab or labview) Pls assist, thanks. Regards Alan Tan

Engineering

Software Architecture

Software Testing

User Interface / IA

ID Proyek: 5485137

Tentang proyek

4 proposal

Proyek remot

Aktif 10 tahun yang lalu

Ingin menghasilkan uang?

Alamat email

Keuntungan menawar di Freelancer

Tentukan anggaran dan garis waktu Anda

Dapatkan bayaran atas pekerjaan Anda

Uraikan proposal Anda

Gratis mendaftar dan menawar pekerjaan

Diberikan kepada:

@Nenad1526

I am a Certified Labview Associated Developer (CLAD) with five years of experience working for the Swiss company Senis AG. I have a lot of experience with data acquisition using the daq card or rs232 communication, and/or modbus communication. Please contact me if you are interested to share more details. Thanks.

$150 SGD dalam 10 hari

5,0

(16 ulasan)

6,1

4 freelancer menawar dengan rata-rata $182 SGD untuk pekerjaan ini

@bchandra1955

Sure, professional engineer from academic institute can guide you , I have used MATLAB in many controls domain problem simulation

$147 SGD dalam 3 hari

4,3

(79 ulasan)

6,1

@kabcpc

Предложение еще не подано

$277 SGD dalam 0 hari

0,0

(0 ulasan)

0,0

@ashwani18in

Hello, I've extensive experience of more than 7 years of LabVIEW development, control loops using PID, fuzzy logic and neural networks along with tremendous hands on experience with M-series DAQ cards, HS-DIO, cRIO, FPGA, IEEE cameras... and many industrial communication protocols like TCP\IP, CAN, Profibus, HART, MODBUS, Ethernet\IP etc. Apart from having knowledge of various sensors, there working principle and calibration, I also have mastery of various software architectures and design patterns. Though the requirement is not mentioned here clearly and needs to be dug, being a CLD (Certified LabVIEW Developer), I assure you that I can develop the required software in 3 days (maximum time after discussing the requirements in detail). you may also reach to me AT ashwani18inATgmailDOTcom or my skype ID is ashwani18in.

$155 SGD dalam 3 hari