I need source code of embedded software

$30-250 USD

Ditutup

Dibuat

lebih dari 5 tahun yang lalu

$30-250 USD

Dibayar ketika dikirim

I need reverse engineering support. I have an electronic card module and with software. Most of software parts are open source already but small parts are not. Software was designed on IAR 6.7 and module has STM32 and ARM Can you provide to open source part and edit/clean/revise codes and be ready to compiler the software for using?

Embedded Software

ID Proyek: 18706369

Tentang proyek

5 proposal

Proyek remot

Aktif 5 tahun yang lalu

Ingin menghasilkan uang?

Alamat email

Keuntungan menawar di Freelancer

Tentukan anggaran dan garis waktu Anda

Dapatkan bayaran atas pekerjaan Anda

Uraikan proposal Anda

Gratis mendaftar dan menawar pekerjaan

5 freelancer menawar dengan rata-rata $173 USD untuk pekerjaan ini

@fermatliu

Hello I am expert for C/asm programming. I do reverse before. Can you give more information about ur project？ Time & Fee should negotiate later, do U agree

$30 USD dalam 30 hari

0,0

(0 ulasan)

0,0

@SimonZhang0212

I have ten years experience in embedded systems, good at using keil or IAR studio,. I think I can help you.

$277 USD dalam 8 hari

0,0

(0 ulasan)

0,0

@hayat38402

I'm an electronic engineer with more than 15 years of work experience. I work as HW designer; FW and SW developer. As HW designer, I work in Altium, KiCad and Orcad and I have experience in development single MCU (Microchip PIC and ARM Cortex) boards with several digital I/O (GPIO, UART, SPI, I2C, PWM) and some analog I/O. I design complete board: power section, MCU section, peripheral section, I design also boards with battery power; so I have experience in low power PCB design. I have also experience in commercial boards (Arduino, Raspberry, Beaglebone ) shields design. I have also experience in bluetooth (both 2.0 and 4.0) PCB design.

$250 USD dalam 3 hari