Portable Tracker Development (Hardware and Firmware) 2G, GPS and RF. All schematic and circuit board at Eagle.

I need all editable files and also in production format (gerber). I also need the list of components (BOM), with code from some supplier (example mouser or digikey or other). I need all component libraries used in eagle For the firmware I need all used libraries, source code and compiled. use the following components STM32F030CCT6 G510-GL LCC (GSM, GPS) RF69(RF Module) Lithium battery 2500ma You should use flash memory to store up to 1000 positions, when I have no gprs signal (download in fifo mode). Tracker must have USB connector to: configure equipment and charge the battery, panic button and accelerometer. Firmware must have following requirements Transmit and receive TCP socket Update firmware via FOTA Activate RF module only when there is no GPRS signal Receive configuration commands via socket, usb, sms Sleep module (disables gps and gsm modules until transmission) ; Data required for submission on the platform equipment series Latitude Longitude Speed direction GPS Date (GMT) number of satellites internal battery voltage inform if the module is in fashion loading battery percentage Generate alert in the cases below. low internal battery jammer Panic Required settings On-the-go communication time in seconds communication time stopped server ip Server port Time to sleep in seconds (where 0 does not use active sleep) configure equipment series with 9 digits Payment in 3 steps: 1) After completing the electronic scheme (25 %) 2) After completing PCB(25%) 3) After completing Firmware (50%)