xmos developer for custom projects with I2S, Ethernet, USB and DAC chips.

$1000 USD / hour

Ditutup

Dibuat

hampir 6 tahun yang lalu

$1000 USD / hour

This project will be on hourly basis first to build the basic DAC with the Xmos chip and USB/Ethernet interface, then to expand out from there once this has been successfully built with the reference designs. I am open to costs however if the initial set up with the reference design shows lack of expertise then the project will be cancelled with respective freelancer. So if you are not familiar with Xmos, I2S, USB, Ethernet and DACs with DSD streaming, DO NOT APPLY. - READ THIS PLEASE. You will be blocked and reported if you blindly tell me you can do this job for less or cheaper without reading the job.

Arduino

Electrical Engineering

Electronics

Microcontroller

PCB Layout

ID Proyek: 17126681

Tentang proyek

8 proposal

Proyek remot

Aktif 6 tahun yang lalu

Ingin menghasilkan uang?

Alamat email

Keuntungan menawar di Freelancer

Tentukan anggaran dan garis waktu Anda

Dapatkan bayaran atas pekerjaan Anda

Uraikan proposal Anda

Gratis mendaftar dan menawar pekerjaan

8 freelancer menawar dengan rata-rata $1.078 USD/jam untuk pekerjaan ini

@seshupower

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded design & programming using pic, dspic controllers and MATLAB codding for Power projects, Boot loaders, Bluetooth & GPS designs,CAN communication, EEprom. UART , RF circuits ,Protocols for networking, wi-Fi routers,OBD diagnosis with CAN bus protocols, Electrical vehicles and AC drives, stepper motor controls. I designed sine wave inverters for standalone and grid tie Inverters. I designed projects like Off line UPS up to 3 KVA, 5kW motor controller for EV,synchronous rectifiers, Solar MPPT chargers, Solar trackers, Battery chargers ,Grid tie inverters design with PLL and feedback control circuit emergency light of 66W and Online UPS control cards, Battery Charging power supplies, LED drivers for PWM controlling and dimming, SMPS, Power supplies. I have experience in schematics and PCB design experience in Altium and ORCAD. I am ready to work for you. Please contact for further discussion.

$1.000 USD dalam 20 hari

4,9

(61 ulasan)

6,7

@Engineer85

Hi I am an Electronic Engineer based in New York. I am interested in completing this job for you. I have read your requirement. I have not previously worked with Xmos But I use I2S, USB, Ethernet and DACs with my current micro controller. I am open to learning Xmos if you have the time to deal with it. Thanks

$1.000 USD dalam 40 hari

5,0

(8 ulasan)

5,8

@RaspberryOculus

Dear Sir, I am an electrical engineer with 19 years experience in this area . I am interested in your project : xmos developer for custom projects with I2S, Ethernet, USB and DAC chips. Please send a private chat message.

$1.111 USD dalam 40 hari

4,6

(18 ulasan)

6,4

@sherifshsffa91

I am able to deliver your target using the following tools : A- STM32F407VG Discovery board which has the following peripherals: 1- DAC for sound interface may be used for xmos 2- I2S for sound interface may be used for xmos. 3- USB OTG Interface. B- XMOS audio interface for Alexa. I had an extension experience working on STM32 ARM Cortex M series and USB VCP mode. If you choose me, I think you won't regret. Best Regards

$1.111 USD dalam 40 hari