embedded systems3

4. Connect a DE0-Nano FPGA board to a UNO board using two jumper wires for data transfer and one wire to connect their grounds. Write codes that allow the microprocessor to use one wire to send a bit over to the FPGA which inverts the bit and sends it back to the microprocessor using the other wire. The bit value to be sent out from the UNO should be input from the serial monitor while the bit received by the UNO (from the FPGA) should be displayed inside the serial monitor window. 5. Modify the previous assignment so that, a bit string of 16 bits is sent from the UNO to the FPGA using a single data wire plus one or two control wires for synchronization (which could be either strobing or handshaking). When a pushbutton on the FPGA board is depressed and released, the FPGA sends a bit string of 16 bits to the UNO for display. Depending on the XOR result on the 16 bits, the bit string sent from the FPGA is either the same as the received bit string or the 1’s complement of the received bit string. The data transfer should be as fast as possible. The original bit string may be hard-coded inside the UNO code or input from a serial monitor. i want to complete just 5th question