Coding a 3D printer on FPGA

Have 2.5+ years of experience in Verilog AND VHDL coding and FPGA Prototyping

i am specialized in hardware and i already wrote (timer and stepper code) module timer(input clk,input start,input[31:0] reload,output reg count ); reg[31:0]current; initial begin current<=0; current<=reload; end always @(posedge clk)begin if(start==1)begin current<=current-1; end end always @(posedge clk)begin if(current==0)begin count<=1; end end endmodule module stepper(output reg signal1,output reg signal2,output reg signal3,output reg signal4); reg cl,s,c; reg [31:0]r; timer t(.clk(c),.start(s),.reload(r),.count(c));

Dear Sir, This is Ahmed Hamdy an Industrial design engineer, I have been working in product design for the past 12 years. I have a lot of products in the market right now. I'm working now as Teaching Assistant at Nile University in Egypt in the Industrial Engineering Department. I'm working in 3D printers for a long time I made and developed many 3D printers so I can help you with anything. I hope to hear from you very soon. Thank you in advance Ahmed Hamdy