A small 4 Layer PCB Layout modify

Dear sir, We can provide the PCB modification service. Please check PMB for business process and bid details. regards,

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Note: Payments will be funded as: 1)Initial:%25 2)Second stage:%15 3)Third stage:%20 4)Final stage:%40 Metin Akin

Hello, I have more 10 years experience with PCB design.

please check your MB.

I have 6+ years of industrial experience in board design ( Schematic, Layout ) in Allegro and Orcad software.

Sir, I have the experience in high speed PCB design. I would like to assist you in the job that you have mentioned. i guarantee the quality and efficient output. Thank you

Hi, I can do it.

Maybe it is a beter way to make new one from schematic? If you vant there is no problem on your way...

I have handled a lot of PCB software, like Allegro, PADS, Expedition, so I think I can do the job.