The problems is this:
I have a fuel gauge that displays empty to full based on a input of volts, but the new sender that is being used will send in ohms, therefore I need to convert the
fuel sender (ohms) to (volts) for the gauge to register correctly.
* Guage requires input of Volts: [ empty = 0.2 volts, full = 4.2 volts ]
* The sender, sends in ohms. [ empty = 0 ohms, full = 90 ohms ]
* the whole system is 12 volt system, but this changes slightly due to charging from a alternative and does vary, so please take this into consideration some how.
I need for a circuit design to make this conversions work, and parts list.
May also hire in separate project to build the convertor of all goes well and you can do it.
Please contatc, leave a message if you need more information.
Hi,
From what I under stad that you have a guage whole output varies resistance interms of fule level. Which you need to convert to voltage to display. We can use a simple opamp cirucit to get it done.
Kindly award the project to share the circuit. Please let me know if you need any clarifications.
Regards,
Ratheesh
$25 USD dalam 1 hari
5,0 (8 ulasan)
4,6
4,6
5 freelancer menawar dengan rata-rata $38 USD untuk pekerjaan ini
I have fully understand the requirements , Please discuss . I am expert electronics circuit designer, i assure you, you will surely like my work
I will use the comparators and operational amplifiers to make this circuit ,
I have read and understand your requirements please open chat window to discuss further
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++