Using Code composer Studio to create a double pulse wave with Texas Instrument LAUNCHXL-F28379D

$12-80 SGD

Berlangsung

Dibuat

lebih dari 5 tahun yang lalu

$12-80 SGD

Dibayar ketika dikirim

I am required to generate a single cycle square wave double pulse (with a large width pulse followed by a small width pulse) that can enable me to change period for each single pulse using code composer studio (CCS). You may refer the attached for reference of the double pulse. Please give comments on each line of the code.

Circuit Design

Electrical Engineering

Electronic Design

Electronics

Microcontroller

ID Proyek: 18528369

Tentang proyek

4 proposal

Proyek remot

Aktif 5 tahun yang lalu

Ingin menghasilkan uang?

Alamat email

Keuntungan menawar di Freelancer

Tentukan anggaran dan garis waktu Anda

Dapatkan bayaran atas pekerjaan Anda

Uraikan proposal Anda

Gratis mendaftar dan menawar pekerjaan

4 freelancer menawar dengan rata-rata $44 SGD untuk pekerjaan ini

@hasnainirshad

I will use two timers on interrupt and then use them to generate the required Waves. Work will be completed on time efficiently.

$75 SGD dalam 10 hari

0,0

(0 ulasan)

0,0

@shmunjpara0201

I can write code in CCS to generate this waveform. Do you need the output on particular pin? I hope any GPIO is okay but not them let me know which pin.

$36 SGD dalam 6 hari

0,0

(0 ulasan)

0,4

@dsarath84

I have exhaustive experience with ti controllers including tms320f28379d. Can alsu use inbuilt CLA in the controller. Please share it will enable me to give effective output is less time than estimate

$52 SGD dalam 10 hari