Setup & start only AVR-GCC project for http requests with ENC28J60 & ATMEGA128
€30-250 EUR
Dibayar saat pengiriman
We need a start and setup a new project in AVR-GCC compiler, with ENC28J60 ethernet controller connected to an Atmega128A AVR microcontroller.
The embedded client system must uses a DHCP client to obtain an IP address and other network parameters such as gateway address and the netmask from your DSL-router or Cable-router in order to make HTTP requests.
Actually we need only the main setup code for the beginning of the project.
ID Proyek: #29272055
Tentang proyek
4 freelancer rata-rata menawar €206 untuk pekerjaan ini
Dear Employer, I am an Electronics Engineer, Programmer, PCB designer and an expert in Arduino programming. I can do this project. I worked on Atmega 128A also. I did almost 100+ projects till now. I can complete this Lebih banyak
Hi! I am an Electronic engineer, PCB Layout, Circuit Design, microcontroller, STM32 microcontroller, C programming expert having past experiences with ,Altium, arduino, pic, AVR, chipkit and Texas instruments microcont Lebih banyak
If you are planning to use Atmel studio which uses avr gcc compiler, I can help you out with the project creation and send you the folder which you can use it for your project setup. It is not really clear as to what Lebih banyak
Hi, if you want to use Arduino IDE, that is simple. The IP address can be determined on the DHCP module by using the necessary arduino libraries. But if you don't want to use Arduino IDE or wanna use to ATMEL Studio 7, Lebih banyak