biofeedback device using pulse oximetry and temperature

$15-30 AUD / hour

Dibatalkan

Dibuat

sekitar 10 tahun yang lalu

$15-30 AUD / hour

Firstly I need to know if this setup is possible. I hope to use this pulse ox chip by corscience; [login to view URL] data sheet; [login to view URL] I want to use this as a sensor for the chipox; [login to view URL] data sheet; [login to view URL] Will this sensor work with the chipox? I would like to connect 2 ChipOx boards up to an arduino nano. Is this possible? The second stage is to use 4 temperature sensors that connect to the arduino. This is the temp sensor I would like to use; [login to view URL] data sheet; [login to view URL] I am open to suggestions about the temp sensor. It is for measuring temp at four points along the forehead. I have looked at thermistors in the past but i think this chip will be more accurate.

Circuit Design

Electrical Engineering

Electronics

Medical

PCB Layout

ID Proyek: 5415231

Tentang proyek

6 proposal

Proyek remot

Aktif 10 tahun yang lalu

Ingin menghasilkan uang?

Alamat email

Keuntungan menawar di Freelancer

Tentukan anggaran dan garis waktu Anda

Dapatkan bayaran atas pekerjaan Anda

Uraikan proposal Anda

Gratis mendaftar dan menawar pekerjaan

6 freelancer menawar dengan rata-rata $23 AUD/jam untuk pekerjaan ini

@waseemsangi

A proposal has not yet been provided

$25 AUD dalam 1 hari

0,0

(0 ulasan)

0,0

@pabasarak

Interesting project. Chipox has not mentioned about their sensors. So cannot comment whether the NJL5501R-TE1 will work with chipox. we can try to get their unit and revers engineer it.

$25 AUD dalam 20 hari