Tutup

Xbreak SamD21 Controller

Proyek ini diberikan kepada RegulViktor dengan harga $83 USD.

Dapatkan penawaran gratis untuk proyek seperti ini
Pemberi kerja bekerja
Anggaran Proyek
$30 - $250 USD
Total Penawaran
1
Deskripsi Proyek

Using existing design as reference, create Xbreak Zero

Consists of:

Sam D21 Processor

SD Card

LCD Interface

Lots of USB 3.1 (xbreak specific)

Type 1 - Consists of 2 X PIO with SPI and I2C

Type 2 - Sam as above but second PIO is selection for Analog IO

6 Pin Pci Express Power

Note I've already done this, but with PCI Express connectors, so larges amounts of the schematic can be used. USB 3.1 Foot Print, and pinout defined.

Note: In addition to main board, three simple add on boards are needed:

1. Stepper Driver - Using USB 3.1 Connecto, connect to typical reprap stepper driver

USB 3.1 Connector

DIP Socket for Stepper Driver

Stepper Driver 4 pin connector

2. Light Thermal Control Board - Using USB3.1 Only and a FET, plus a external thermistor, drive a "hotend" heater

3. Heavy Thermal Control board - rev of above - but adds a 6 Pin Pci Express Connectior

Diberikan kepada:
Keahlian yang Diperlukan

Ingin menghasilkan uang?

  • Atur anggaran Anda dan jangka waktunya
  • Uraikan proposal Anda
  • Dapatkan bayaran atas pekerjaan Anda

Pekerjakan para freelancer yang juga menawar di proyek ini

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online