I have a PCB that has four digital inputs. In normal use the inputs are low and the output is low. If one of the inputs goes high then the output will go high. The current program works as intended and there is no issue with it.
I need to change one input so that it will toggle the output with each consecutive high. ie. first high on the input will cause the output to go high and the next high on the input will cause the output to go low.
I attach the whole program. If you require more info please email asap before placing your bid. Once the project is awarded the work is to be completed within 24 hours. Thanks for bidding and good luck!
PS. The PCB has 4 x digital inputs, 4 x DIP switches, one power input and 2 x power outputs. This info may help you understand the program better.
Hi, sir. It is an easy task just as you say, I make it done in about 1 hour, I am an expert C programmer with 7 years work experience, trust me that I can do it with your 100% satisfied!
$35 AUD dalam 0 hari
0,0 (0 ulasan)
0,0
0,0
12 freelancer menawar dengan rata-rata $57 AUD untuk pekerjaan ini
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
Let's begin just now...........
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
Hello,
We are a team of two engineers that can provide you with this solution. We have worked on such project and we can provide the answear withn 24h .
Best Regards,
CDE Team.
Both of us can do this. I suggest you one logic to try out.
Please use the following code:
if (highCount%2 == 0)
{
rememberToggle = 0;
}
else
{
rememberToggle = 1;
}
if (rememberToggle == 0)
{
//handle output
}
else
{
handle output
}
Hi! I've read your project description, and I have the required skills on .C Programming
complete the tasks of project. If you have anything to ask you can please.
I have expertise to meet your project requirements. Thanks
Hi,
I have years of experience programming in C and will be able to make your changes in just an hour or two.
Please check my portfolio for examples of my work, one program in particular is quite relevant, and that is the chip+pin reader which was also written in C.