CAN bootloader for Freescale MPC5634

Proyek ini menerima 9 penawaran dari para freelancer berbakat dengan harga penawaran rata-rata $1397 USD.

Dapatkan penawaran gratis untuk proyek seperti ini
Pemberi kerja bekerja
Anggaran Proyek
$750 - $1500 USD
Total Penawaran
Deskripsi Proyek

Develop and produce C source code for the Freescale MPC5634 microcontroller using the TRK-MPC5634 evaluation board. The software will have two functions:

1) At boot up time, if a PC requests the microprocessor memory to be programmed over CAN bus, the bootloader will handle firmware and data area programming. The Windows PC software, USB-CAN interface, programming communications protocol will all be provided. These are already developed and working. The firmware and data areas will be arranged in the on-board Flash EEPROM of the MPC5634 as listed in the memory map below. The bootloader must communicate with the PC software over CAN bus, erase Flash EEPROM sectors as required and write the binary data received from the PC to Flash memory. The bootloader will be able to support CAN bus speeds of 1Mbit/s, 500kbit/s and 250kbit/s.

Memory Map

Bootloader 0-0xffff

Data1 0x10000-0x1ffff

Data2 0x20000-0x3ffff

Firmware 0x40000-0xfffff

2) If programming is not required at boot up time, jump to the start of the firmware area and allow the system to boot up normally.

The datasheet for the TRK-MPC5634 evaluation board is attached to this document. The evaluation board includes Codewarrior integrated development environment with JTAG debugging and programming so includes all required hardware and software to complete the project.

The deliverable of this project is the completed C source code for the bootloader developed using Freescale Codewarrior.

Ingin menghasilkan uang?

  • Atur anggaran Anda dan jangka waktunya
  • Uraikan proposal Anda
  • Dapatkan bayaran atas pekerjaan Anda

Pekerjakan para freelancer yang juga menawar di proyek ini

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online